View Single Post
Old 02-14-2011, 07:08 AM   #5
Numb
Gnarly Adventurer
 
Joined: Dec 2010
Location: Virginia
Oddometer: 190
I had initially installed my guards on the bar ends then tried to mount to the topclamp but had to reverse that because the guards were quite a ways off ... I've got them mounted, but there is a lot of tension on the small screws in the top clamp (especially for a custom part...). hope it doesn't become an issue - would like to have heated and bent them in about 1.5" to allow them to fit more naturally but don't have a workshop to do that right now.
Numb is offline   Reply With Quote