View Single Post
Old 02-15-2011, 03:09 AM   #97
yamahaman OP
wannabe bike builder
 
yamahaman's Avatar
 
Joined: Jul 2010
Location: melbourne Australia
Oddometer: 223
Laugh another night in the machine shop

I had another night in the machine shop on the mill and I have done the easy part of the milling.


Here I am getting the mill ready to drill the bolt holes for the sprocket. Set the indexing head up and now checking the slot drill with the sprocket holes to make sure the first one lines up and then the rest will follow on with the indexing head.

Now I am putting groove's in to reduce weight and to allow for the stealth sprocket rivet's to fit in as I think they are the best sprockets on the market.

Here is the alignment with the hub ready for the fingers to be milled out.


Here is the front and back of the sprocket carrier. There is one last job and that is to mill the fingers in the back of the carrier and fit the bearings and seals, all finished soon.

__________________
Build it and you will ride

My crazy bike build
yamahaman is offline   Reply With Quote