View Single Post
Old 03-11-2011, 06:24 AM   #6
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: El Paso,NM
Oddometer: 4,085
Quote:
Originally Posted by oclv454 View Post
you mention that the mid pipe is pretty much the same as the old one. If you can do me a favor......when you friend comes over with the old pipe, see if the bend in the new pipe is the same as the old one. I am hoping they bent it in a way so as to bring the inlet end of the carbon pipe closer to the center of the bike. On my existing LV carbon, the front of the pipe hits my racks and if they bent the new link pipe a bit more, it will eliminate this problem for me. Nice write up. oclv
I played a little with turning of the mid pipe while held still.....and I could change the angle of the pipe to the point that the 30mm spacer would fit..... But the pipe would be hanging too far down ( about 30mm) for the CF collar to reach. It could just be something on my bike.......And imho really not a big deal.......well at least for me. He said he`d be over today....So I will measure the angles of the mid pipe.

Erling
ebrabaek is offline   Reply With Quote