View Single Post
Old 03-17-2011, 12:22 PM   #14
Rapid Dog OP
bikes, booze, broads...
 
Rapid Dog's Avatar
 
Joined: Oct 2003
Location: Strangel Living West of Hell
Oddometer: 8,951
Thumb

Quote:
Originally Posted by bmweuro View Post
Floats are not pre set however they are normally pretty darn close. The top of the float should be parallel with the bottom of the carburetor.
check
Quote:
Replace your float needles as well.
check
Quote:
Hone the float needle seat with a small piece of Scotch Brite wrapped around a screwdriver and a little squirt of WD40. Make sure to clean it with carburetor cleaner and a little air when you are finished.
I'll give this a try...
__________________
'09 450 EXC Nani Roma Limited/'08 R1200R-Gone to the Hipsters/'02 Dirty lil KTM400EXC-gone to a good home/'10 WR290X/R buhbye!
'81 R100RS Rattlecandy Red/'06 950 ADV Orangeboom/91 R100GSPD Derelict

Rapid Dog is offline   Reply With Quote