View Single Post
Old 03-22-2011, 09:14 AM   #24
blaine.hale OP
Beastly Adventurer
blaine.hale's Avatar
Joined: Feb 2009
Location: Atlanta, Ga
Oddometer: 3,267
Just ordered an engine rebuild kit and control cables from Hugh's Bultaco. Hopefully this enough to get to a point where I can crank it back up and ride a bit this summer.
Can anyone list the tools I will need (outside of the standards) to tear the engine apart? As far as I know, a clutch holder, bearing puller, something to hold the magneto etc
Any specialty tools and what not I should make or buy?
Thanks guys!
1974 BMW R90 /6 | 1968 Bultaco Matador MK3 | 1973 BMW R75 /5 Toaster LWB | 1966 Ducati 250 Monza | 1976 Ducati 860 GT | 1977 Moto Guzzi LeMans 850
blaine.hale is offline   Reply With Quote