View Single Post
Old 03-22-2011, 09:47 AM   #25
hardwaregrrl
ignore list
 
hardwaregrrl's Avatar
 
Joined: Jan 2006
Location: Atlanta
Oddometer: 7,079
Quote:
Originally Posted by blaine.hale View Post
Just ordered an engine rebuild kit and control cables from Hugh's Bultaco. Hopefully this enough to get to a point where I can crank it back up and ride a bit this summer.
Can anyone list the tools I will need (outside of the standards) to tear the engine apart? As far as I know, a clutch holder, bearing puller, something to hold the magneto etc
Any specialty tools and what not I should make or buy?
Thanks guys!
If you're splitting cases, you'll need to make or buy a case splitter. Also, have you seen Tenorjazz resto thread??? Sorry if this is 205'd, Blaine:
http://www.advrider.com/forums/showthread.php?t=660024 Did you get new jets for the carb?
hardwaregrrl is offline   Reply With Quote