View Single Post
Old 04-03-2011, 07:15 PM   #5
jesusgatos OP
fishing with dynamite
 
jesusgatos's Avatar
 
Joined: Nov 2006
Location: on the road
Oddometer: 2,358
Just posted this on thumpertalk:

Quote:
Originally Posted by jesusgatos View Post
Am building a custom trailbike, putting an XR250R engine into a 2005 CRF450R chassis. Fitting the new engine right now, and would like to know where the CRF front sprocket is located, relative to the chassis. Would sure appreciate it if somebody could take a quick measurement for me. All I need to know is the height from the bottom of the forging to the centerline of the sprocket (pic shows measurement requested). Thanks in advance.

jesusgatos is offline   Reply With Quote