View Single Post
Old 04-16-2011, 11:52 AM   #23
ebrabaek OP
Beastly Adventurer
 
Joined: Jan 2010
Location: Grand Valley, Colorado
Oddometer: 4,676
Quote:
Originally Posted by YetiGS View Post
Is there a way to reinforce the beak? The HP2 uses an external beak support but I'd prefer not to do that...
Yes. And that would be simple to do...... But the more I look at this....( looking in the garage while getting tools for the table assembly...).... I see that it would next to impossible to make a new beak....and reuse the black plastic......Very complex lines and angles..... but now leaning towards.....making a new front plastic.....longer off course....and reuse the stock painted beak...... Some serious design went into the stock beak....and it will be hard to break the lines...... well....ehh... successfully...

Erling
ebrabaek is offline   Reply With Quote