View Single Post
Old 04-22-2011, 10:02 PM   #35
Brtp4 OP
Powdercoat it.
Brtp4's Avatar
Joined: Sep 2006
Location: Bend, OR
Oddometer: 1,974
Parts needed:

A few additional parts were needed to fit it. First, the throttle cables come off the stock carb on the left side, on the FCR they are on the right. Additionally, they are really close to the upper motor mount:

I called Motion Pro, and they sent me cables with 45 degree elbows. I had to be really careful so they did not contact the cylinder head and melt the housing. Additionally, the bracket is threaded, so I had to spin the cables into the bracket before putting the carb on, otherwise.....not enough room to spin the cables into the threaded bracket. I ended up carefully drilling out the threads on this bracket:

Once I got this done, it was much easier to fit, position, and adjust the cables.

Bend, OR

Brtp4 screwed with this post 10-04-2014 at 05:49 AM
Brtp4 is offline   Reply With Quote