View Single Post
Old 05-31-2011, 10:20 AM   #844
Poolside OP
Syndicated
 
Poolside's Avatar
 
Joined: Apr 2003
Location: Long Beach, CA
Oddometer: 11,751

Little help, please.

A little birdie told me I should verify a dimension on a few of the R models to ensure that the wiring harnesses will fit. Sounds like a good idea to me, you know, before making a big batch of wiring harnesses.

I need to verify the dimension illustrated below, on the GS, RT, and ST.

If anyone can take that measurement on a GS, RT, or ST. I'd very much appreciate having confirmation of the measurements I took. I want to make sure they are correct. JVB has an ST so maybe he take the measurement on his bike.

Thanks all.


This is the distance to measure.



Measure from the WIRE END of the air temp sensor connector...

Picture by marchyman


To approximately where the left side relay screw is located.

Picture by myblubeemer


__________________

IICE Air Hotrod your GS  Fuel Injection  Tech Info  Buy  Order List  Installation

Poolside screwed with this post 06-01-2011 at 02:52 AM
Poolside is offline