View Single Post
Old 06-01-2011, 04:22 PM   #73
TimFinnegan
Rally addicted
 
TimFinnegan's Avatar
 
Joined: Feb 2010
Location: Germany
Oddometer: 115
Quote:
Better still might be to have a backing plate the same as the inner diameter of the headtube so you end up clamping it and distributing more load around the headtube. If there's room to do so of course. Pretty sweet nonetheless.
Sure, you need a plate to have a flat ground for the nuts, but that might also be a good version.
The problem with the threads in the frame is the force is acting against the frame only at probably 2-3mm eachs screw directly in the frame.
By having a plate inside an bigger holes in the frame the force would act against a much bigger area.

But as takman said: pretty sweet nonetheless!

Cheers
Marco
TimFinnegan is offline   Reply With Quote