View Single Post
Old 06-19-2011, 06:46 PM   #35
Sibbo
Gnarly Adventurer
 
Joined: Sep 2009
Location: Tweed Valley , Northern NSW
Oddometer: 352
So Ontic , what are you like at fiberglass mould making ? There is a market mate .


and mould making is dead easy ....if slow .

and thanks for the explanations regarding the forks .When I looked at my ST forks and clamps I thought them perfectly adequate and thought the g/s was the same , apparently not .My top isn't that satisfying but is a bit of 5 mm sheet metal ,the bottom is a good looking casting .
Sibbo is offline   Reply With Quote