View Single Post
Old 07-12-2011, 07:02 PM   #47
plane_ben OP
Adventurer
 
plane_ben's Avatar
 
Joined: Mar 2006
Oddometer: 56
Got alittle farther along with my trials mods. I made the subframe much skinnier. After looking at the Peter Gaunt bike for a few more hours, I realized how they did it. First was to cut off outer down support from the shock mount to the outer swing arm mount tab. I refitted the down support by shortening the required amount and rewelded onto the top corners of the rear engine mount.





Then I made two plates for either side and located the holes for the swingarm bolt, and used some smaller dia. tube to slide into the rear engine mount cross tube. These I welded to the bottom of the side plates. I also welded the footpegs on and made the rear brake lever pivot.







Having lots of fun with this project. Next on the agenda is shorting the swingarm 1". Then I'll tackle the biggy, front fork rake.
plane_ben is offline   Reply With Quote