View Single Post
Old 08-01-2011, 12:37 PM   #68
Beastly Adventurer
Joined: Oct 2006
Location: NW PA
Oddometer: 1,044
Cry Problems

I was using the Harmonizer on my Ural Patrol this afternoon, I had done it a week ago with my Twinmax but wanted to fine tune it. OK I wanted to play with my new toy. Everything was close, as expected. Adjusted idle and off idle with no problems. Went back to fine tune idle speed and suddenly the display went to -155 mbar and no RPMs. Disconnected the hoses, they are clear and no leaks as they hold oral applied pressure. Reconnected and let it zero, all it does is read 000 mbar. Tried it on my R1100R, which I did with the Harmonizer on Saturday, with the same results, 000 mbar.

The shortest distance between two points is boring.
Railbender is offline   Reply With Quote