View Single Post
Old 08-01-2011, 01:35 PM   #70
Grok OP
Beastly Adventurer
 
Grok's Avatar
 
Joined: Jan 2003
Location: Folsom, California
Oddometer: 3,563
Quote:
Originally Posted by Railbender View Post
I was using the Harmonizer on my Ural Patrol this afternoon, I had done it a week ago with my Twinmax but wanted to fine tune it. OK I wanted to play with my new toy. Everything was close, as expected. Adjusted idle and off idle with no problems. Went back to fine tune idle speed and suddenly the display went to -155 mbar and no RPMs. Disconnected the hoses, they are clear and no leaks as they hold oral applied pressure. Reconnected and let it zero, all it does is read 000 mbar. Tried it on my R1100R, which I did with the Harmonizer on Saturday, with the same results, 000 mbar.

I am sending you a PM confirm your address. I'll expedite one out to you immediately.
I'd appreciate you returning the defective unit to me so I can do a fault analysis!
Thanks!
__________________
You can't go backward if you are facing the right direction
Grok is offline   Reply With Quote