View Single Post
Old 07-18-2005, 09:51 PM   #5
meat popsicle OP
Ignostic
 
meat popsicle's Avatar
 
Joined: Feb 2004
Location: Circumlocution Office of Little Dorrit
Oddometer: 14,178
request

I am lacking any serious measurement ability. Could someone with a set of calipers measure the diameter of the subframe where the toolbox tabs attach, the distance from the center of that frame member to the center of the tab hole where the bolt goes, and the diameter of the bolt hole?

I figured from my rough measures that a 1/4" hole will be sufficient for the clamp to pass the bolt without getting in the way but it might be nice if it were snugger.

Thanks!
__________________
Kronreif Trunkenpolz Mattighofen LC4 640

Its not so much staying alive; its staying human that counts.
meat popsicle is offline   Reply With Quote