View Single Post
Old 09-02-2011, 11:01 PM   #21
Spud Rider OP
Beastly Adventurer
 
Spud Rider's Avatar
 
Joined: Jun 2008
Location: Idaho
Oddometer: 3,601
Quote:
Originally Posted by rufus View Post
I just got back from riding the continental divide. About 2500 miles. I installed 1 roller just before I left. At about the 2,000 mile mark it was worn into the bolt. I threw it away and put the other one on. The second one is wearing on the out side. The inside is worn enough that it rattles up and down and makes a horrible racket when riding. I greased the first one and didn't grease the second one.
I'm sorry to hear that, Rufus. Thank you reporting your problem. If I may ask, do you have a 45T rear sprocket, or a larger rear sprocket? Did you use a 5/16-inch bolt, or a 3/8-inch bolt? Also, did you keep the OEM "chain slipper" behind the countershaft sprocket, or did you install a sealed bearing roller in that position?

Spud
__________________
2005 XR650L: Shorai Battery Relocation, Spud Oil Cooler, XR650R C/S Sprocket, Reinforced Subframe, Chain Slipper Roller, Performance Design Lowering Link, Baja Designs Headlight, FMF Hi-Flo Header, ManRacks SD Rack, ManRacks Front Fender Farkle, CST Surge I Front Tire, D952 Rear Tire, Tusk D-Flex Handguards, Uni Air Filter, No-Toil Evolution air filter oil

Spud Rider screwed with this post 09-02-2011 at 11:38 PM
Spud Rider is offline