View Single Post
Old 07-28-2005, 11:29 AM   #84
Jim Bud
Beastly Adventurer
Jim Bud's Avatar
Joined: Apr 2003
Location: Castle Rock, CO
Oddometer: 3,439
Since we now have a bearing expert on board...

I have a question, and I know nothing about bearing, most everything else of course, but not bearings.... :)

My questions is; does the need to tighten the rear pivot bearings ( which I suspect that many bikes do not have done until it's been running loose for a while) have a negative effect on the rear drive bearings?

In other words, if the rear pivot is run loose for a sustained time, will it screw up the final drive bearings??
Jim Bud

"Nearly all men can stand adversity, but if you want to test a man's character......give him power".....Abraham Lincoln
Jim Bud is offline   Reply With Quote