View Single Post
Old 09-15-2011, 02:01 AM   #53
far
ADVreader
 
far's Avatar
 
Joined: Jul 2010
Location: Los Andes,Venezuela
Oddometer: 136
Question

Quote:
Originally Posted by cyborg View Post
To test the new dual-fan setup I just installed and the RED 200F water temp sensor I also installed after the second fan install (OEM sensor is BLUE 220F, see both below) I did the 15 minute idle reset, which is also a good way to get the bike up to full temp.



5-7 minutes into the run the bike was up to 4 bars and holding steady and the dual fans were cycling on and off regularly, good solid blasts of hot air off both sides, which means the bike was holding steady temp regulation at a lower temp (200F) than before at idle, a good sign.
┐Did anyone try the 200F temp sensor without install the right fan?
┐This 200F water temp sensor is the same found in the auto-stores, I used to have a LS1 wit a 160F thermostat for better performance.

The 990 Open thermostat
The thermostat opens at 75░ C. or 167░F
The fan switches on at 102░ C. or 215.6░F
KTM source.

I will like to test a 160░F temp sensor but could make any harm and were to find this one maybe a auto-stores have a similar one.

far screwed with this post 09-15-2011 at 02:31 AM
far is offline   Reply With Quote