View Single Post
Old 10-04-2011, 08:49 AM   #13
CycleDoc59 OP
Wrench Rider
 
CycleDoc59's Avatar
 
Joined: May 2006
Location: East Virginia
Oddometer: 857
Quote:
Originally Posted by alexisan View Post
ok, then I am going to get the Goop stuff too. Will also just fill the niples. Would you go for glue as well or just Goop?
Just Goop. When you buy it, the tube may say "Automotive", or "Marine" or "Plumbing".
But it's all the same stuff.. Clean the rim/spoke ends, and finally wipe down w/alcohol.
Goop will shrink when it sets, put a blob on each spoke end (top 1/4 of wheel), let
it set up for a few hours, then repeat for each quarter of the wheel. Let it cure for a couple
days, then go around and do it again, as there will be voids/bubbles. Let it cure again,
then recheck; you should be done.....!
CycleDoc59 is offline   Reply With Quote