View Single Post
Old 10-07-2011, 04:46 PM   #3
supershaft
because I can
 
Joined: Sep 2010
Location: San Francisco Bay area
Oddometer: 8,786
IMO, peanut valve covers don't look right with head fins that have been squared off like all the head fins that came with the /7 valve covers. Check it out: /5 and /6 head fins and maybe even the cylinder fins are more rounded to match the peanut valve cover.

Plus the /7 covers sure do protect your engine more in a spill.

I would only replace that stuff it was leaking. Valve cover gaskets leaking? Be careful! The head's valve cover gasket surface warps a lot and causes the valve cover gaskets to leak. Sometimes new gaskets just leak more until you get the surface machined.

Cable junction boxes are almost always filled with grit. Clean them and seal them with electric wire insulating shrink tube. It works perfectly for almost forever!

supershaft screwed with this post 10-07-2011 at 04:53 PM
supershaft is offline   Reply With Quote