View Single Post
Old 10-11-2011, 07:43 PM   #47
anonny OP
What could go wrong?
anonny's Avatar
Joined: Mar 2007
Location: Beautiful Revelstoke BC
Oddometer: 5,697
Work has been demanding and I just finished a run of 2 weeks all 12hr days so precious little has been done, the time was used to order parts and take apart a few smaller pieces. Another week and I should get a life back.

Finally some decent results, I bet I have striped this thing 4 times if Ive done it once. Had to use a powder primer to stop the offgassing followed by the chrome powder, now I just have to reshoot a few of the scruffy pieces.

And the new parts are arriving daily, NOS 2nd over pistons and NOS foot peg rubbers.

Carb kit's, points, plugs and condenser
Kawasaki H1 build thread

71- 450 Honda CL re & re

Just another pathetic sheep following the herd

anonny is online now   Reply With Quote