Refreshing the XL600RMG
View Single Post
11-11-2011, 04:09 AM
Joined: Sep 2007
Location: The High Country, Vic, OZ
The piston is still in good condition but I am going to replace it, the piston for this engine is NLA so I am going to put a later XR version in it.
It has a bit of blowby past the rings.
The pin is also good but will be replaced, the small end has some wear and a very tiny bit of movement when the pin is in however this engine is very quiet and has virtually no mechanical noise
View Public Profile
Find More Posts by RED1