View Single Post
Old 11-18-2011, 12:05 PM   #14
scarygary
Drawing blanks
 
scarygary's Avatar
 
Joined: Sep 2007
Location: Toronto ON
Oddometer: 362
I tried out some Suzuki V-Strom bars on my R65 monolever. I had a set kicking around the garage and they seemed just about right. I was also looking for something higher and wider than the K75S bar that I had on (the S bar is not much different). They are probably in between the US high and the S bar.

Controls, clamps and cables all work fine. I cut about 3/4" off each end to make them just right for me. I am sure you can find a good used set cheaply.

They are about 1" higher and an inch or so wider than the K75S bars. The width in effect shortens the reach. A nice compromise between too low and too high.







K75S bars for comparison

scarygary screwed with this post 11-21-2011 at 07:54 AM Reason: Two more pics added.
scarygary is offline   Reply With Quote