View Single Post
Old 11-20-2011, 06:58 AM   #26
willys OP
Beastly Adventurer
 
willys's Avatar
 
Joined: Jan 2006
Oddometer: 2,904
The only gasket I have had issues with is the base gasket if touched for some strange reason. It's sililar to a halogen bulb. Once it is contaminated it seems to weep a bit. Best way is to wear fresh rubber gloves and use permatex sealant 515 I think it's called both sides of the gasket. No oil or grease anywhere near it and it will be fine.
Side case gaskets, I use stock gaskets and have never had an issue Head gaskets, either stock or already machined out for the big bore kits, again never a problem.


Carry on Gents...all's good.
__________________

willys screwed with this post 11-20-2011 at 10:56 AM Reason: to stay on topic
willys is offline   Reply With Quote