View Single Post
Old 11-24-2011, 04:40 AM   #66
Dan Căta OP
Beastly Adventurer
 
Dan Căta's Avatar
 
Joined: Jun 2008
Location: Cluj, Romania
Oddometer: 1,549
Hi all,

As per the last shipment and from now on, I will also put in the kits the small screws that hold the plate, along with the nuts.

After you screw them in and tighten the nuts, please punch the end of the screws with a chisel or something close to it, in a "+" pattern, just for safety so the nuts would not fall inside the TB.

It's very important that you put something to hold resistance on the other end of the screw when you punch it, otherwise the shaft might bend!

And I would really appreciate some reviews from the riders I have already sent them to.

Thanks,
Dan.

Dan Căta is offline   Reply With Quote