View Single Post
Old 11-24-2011, 07:17 PM   #67
Ron from BC
Beastly Adventurer
 
Ron from BC's Avatar
 
Joined: Jun 2008
Location: Vancouver Island
Oddometer: 1,322
Quote:
Originally Posted by Dan Căta View Post
Hi all,

As per the last shipment and from now on, I will also put in the kits the small screws that hold the plate, along with the nuts.

After you screw them in and tighten the nuts, please punch the end of the screws with a chisel or something close to it, in a "+" pattern, just for safety so the nuts would not fall inside the TB.

It's very important that you put something to hold resistance on the other end of the screw when you punch it, otherwise the shaft might bend!

And I would really appreciate some reviews from the riders I have already sent them to.

Thanks,
Dan.


Any chance you could post a picture showing the plate etc that you're referring to? Being an amateur I don't want to make any mistakes....

Thanks Dan
__________________
'02 BMW R1150 GSA
'06 Kawasaki KL250H Super Sherpa
Ron from BC is offline   Reply With Quote