Quote:
Originally Posted by Ron from BC
Any chance you could post a picture showing the plate etc that you're referring to? Being an amateur I don't want to make any mistakes....
Thanks Dan
|
Hi Ron,
It's the throttle plate I am talking about
After you insert it in the shaft and move the pulley a couple of times until it is centered, put the screws in the kit inside the shaft and tighten them. Then secure them with the nuts and then you punch the end of the screws in the "+" pattern, to make sure the nuts would not come off because of the vibration or anything. They should not come off anyway, but just as a safety measure...
Dan.