View Single Post
Old 12-13-2011, 04:50 PM   #112
Astolfo
Wicked Slow
 
Astolfo's Avatar
 
Joined: Apr 2008
Location: The Mental Asylum
Oddometer: 795
Quote:
Originally Posted by JRWooden View Post

Astolfo - I'm just guessing, but yeah I would think that if the carbon fiber part is going to be attached to (or even better yet) spaced slightly away from the bottom of the stator cover that 400-degree resin should be fine.

I'm curious - Is the higher temp. resin more expensive? Harder to work with?
mix ratios are very important as curing temp and time, and air. vacum bagging and oven although not a must, is better. I will see if i can get the a mold out of my bike and make one. but it will not happen until next year. besides it is cold around here
__________________
1995 R1000 GS 1998 R850 GS 1999 R1000Gs 2007 KTM ADV 990 2009 R1200GS
2012 F800GS White & Blue Trophy
2014 GSA
Astolfo is offline   Reply With Quote