Quote:
Originally Posted by Astolfo
so...a 400F resin should be good enough? I do not want to end up with a bunch of melted resin on my bash plate....  |
Yep... Post heat cure for sure.... I use a good mix from a alchemist in Mid CA....... It holds up to about 450F...... Good stuff...With a post cure that is easy to work.... I made the Bash plate from it........ and have made countless side covers....etc. with it. I just meant that before making one...... I wanted to make sure that this would benefit the stator.... Ie... the header is in fact a catalyst. You will also effectively stop any heat transfer out from the stator cover...... So if someone stepped in and stated that this is an issue.... I'd whip up one in a heart beat... I'd make it from Kevlar (Aramid) though.... better protection...and heat isolator....... Could even make'em pretty...like this.....
Erling