View Single Post
Old 01-02-2012, 06:12 PM   #221
JRWooden
Beastly Adventurer
 
Joined: Jul 2008
Location: The great state of confusion
Oddometer: 4,204
Quote:
Originally Posted by Toadride View Post
One thing my mech did stress was the stripping off of the non conducting anodized surface to get a good ground.
I'm wondering if that will do any good or if the case is even bonded to the ground side of the circuitry ???
I reckon I"m going to have to get the ohm-meter out and check continuity from the ground wire to the heatsink...
They sure didn't do anything at the factory to enhance the grounding I can tell you that much..........
JRWooden is offline   Reply With Quote