I pulled out my old 950 headlight that I cut down to the clear plastic. A 2x2 rigid LED fits nicely in the top and I suspect a 2x3 would fit nicely in the bottom. The rigid lights are shorter than the stock headlight housing so you could make brackets and mount them in place of the stock headlight unit while retaing the stock plastic so that the headlight wouldnt look too odd at first glance. between the two lights you would draw about 30 watts iirc. Same light spectrum as the HID, probably not quite the same distance but also a fraction of the cost of a good HID, no ballast issues, instant on, no bulbs to burn out (Yes HID bulbs can go bad). etc etc.
My intuition nearly makes up for my lack of good judgement.
Just installed my new trolling motor