Originally Posted by alpo996
Nice job there, LAYNFRM! That project is on my to do list. I had thought that the double-row lamp would be too thick to work with the high fender, but you got it in there. Please PM me with project pics if you have time.
i had to grind about 1/4" off the outside of each of the supplied rigid mounts, then hose clamped them to the 1ish inch aluminum tube that is part of the headlight/guage cluster mounting setup. hose clamps held the same light through the Baja 500 for me, so i think it'll hold on here, lol.
i posted all the pics i took. the whole thing was really straightforward. just measure the width the bar takes up and cut it out of the lower grille. then i pulled the side fairings off for easier access to get it all straightened out and wired up. the horn had to be turned sideways, but the wires still reached. i'll take some pics next time i pull the front end apart.