View Single Post
Old 02-04-2012, 02:40 PM   #72
AdvGa
Beastly Adventurer
 
AdvGa's Avatar
 
Joined: Nov 2009
Location: Atlanta Metro
Oddometer: 1,320
Quote:
Originally Posted by StmbtDave View Post
I had the exact same leak. Don't mess with Formagasket. There is no gasket between the sensor and the case, only an O-ring. You can pull the cover and very little oil will leak out. The local dealer didn't have the proper O-ring in stock so I picked one up at Ace Hardware. Seems to me the proper one is 27.5mm x 2.5mm and the one I used was 27mm x 2.5mm. So far, no leaks .Dave
Well, it started leaking again, the Gear Shifting Sensor, so I found this O-Ring at Ace Hardware

1 3/16 x 1 3/32 #20 O-Ring Stock # 35737B that seems to be working in addition I Cut a Gasket from Flat Gasket Material to cover the Plastic Flange.... also,

I had to Epoxy the Exit Wires out of the Plastic Sensor since it appeared Oil was Leaking out of the Wire Exit Area.

It appears this Plastic Sensor is too flimsy with only 2 screws holding it in place.

When I did the Valve Check, Replaced the Oil Pressure Sensor that appeared to be leaking out of the Plastic area where the Wire Connects.

Thanks for your help !!
AdvGa is offline   Reply With Quote