View Single Post
Old 03-02-2012, 04:22 PM   #61
dorkpunch OP
dorkpunch's Avatar
Joined: Aug 2006
Location: Blackfoot, ID
Oddometer: 5,373
More. Got one of the muffler mounts built and welded on. Made a sort of isolation mount out of a rubber stopper.

Drilled a hole through it:

Cut it in half.

Welded up a bracket... Its ugly. Drilled and tapped a hole in the rearset mount, and here it is installed:

Still plan on doing one more just like it a little further back that will hang off of the frame where the brake light switch used to be.

Also got the pin welded to the kickstand tab and then the hole for the cotter pin drilled.

Now to weld the tab to the rearset on the left side!

"I've been going to this high school for SEVEN YEARS. I'm no dummy!"
-Charles De Mar.
dorkpunch is offline   Reply With Quote