View Single Post
Old 03-14-2012, 05:24 PM   #93
igormortis
Beastly Adventurer
 
igormortis's Avatar
 
Joined: Dec 2006
Location: Moving further away from Wellington, New Zealand
Oddometer: 1,199
FYI, here are the bits I used to make the GS wheel fit the KTM forks with HPM/R-dubb clamps.

IMG_0009

From left to right:

- Monolever road bike axle. 30mm, 25mm (mine was from an ’85 R80)

- standard axle spacer. 11mm
- standard axle spacer, machined down to approx 17mm (spacers and axle came from the same road Mono bike)

- steel sleeve, 0.5mm thick to bring the BMW axle up to the KTM’s 26mm. Split to allow tightening. Approx 58mm in length, with about a 4mm “hat” to keep it located. This is against the inside of the axle clamp and acts as an additional spacer.

- steel shim. This is what the hat part of the sleeve tightens against when the axle is pulled into position by the end bolt.

Not pictured: Axle end shim and bolt. These are standard items from the above Monolever bike.
igormortis is online now   Reply With Quote