View Single Post
Old 03-26-2012, 09:50 AM   #305
wrk2surf OP
on the gas or brakes
wrk2surf's Avatar
Joined: Dec 2007
Location: THE exact center of California/Bass lake/Yosemite
Oddometer: 6,845
Circlip and magnet

go into the rotor

This is my new rotor I am getting ready to install for the Mexican 1000 rally. It has a drilled out spot in the cooling cut (at 6 o'clock positon)

I dont know if you have an OEM KTM rotor with this done or what size it is. So you would have to use a drill press and the appropriate sized bit to drill yours out to fit the magnet set up you have. As you can see the hole "captures" the magnet and is held by the C clip.

hope this helps
Thanks for the 2015 support: BELL HELMETS, SCOTT USA, Kriega USA, SEATCONCEPTS.COM , Galfer USA,, GPR stabilzers, Sidi/Motonation, Masters paint and body, Magura , Motolab , Loctite and Dunlop tires .
wrk2surf is offline   Reply With Quote