View Single Post
Old 04-15-2012, 07:39 AM   #8
England-Kev OP
Beastly Adventurer
 
Joined: Feb 2007
Location: England. Somewhere on the Canal.
Oddometer: 3,494
Every time I make a little progress with this bike, I always seem to get kicked back and today has been no exception.

As you can see I have made some progress, and I think it looks pretty good for my first attempt at cleaning up a triple...







I have spent the best part of the weekend cleaning and degreasing my new motor, and today I thought I would get the bottom end in the frame, so I pulled the top end off the motor to go for vapour blasting and polishing, only to find that there are no small end bearings in the rods, no clips in the pistons, and the crank all rusty. I should have realised that something was wrong when every screw was loose, including the oil pump.
So are cranks interchangeable across the H1 range, I have a later crank here that came with the bike, will that fit the earlier cases? and are all small end bearings the same? as I will need to find some of those. Oh well, it looks like a full engine build now as well then.







Who knows, I might even get it going this year.
England-Kev is offline   Reply With Quote