View Single Post
Old 04-15-2012, 01:21 PM   #124
supershaft
because I can
 
Joined: Sep 2010
Location: San Francisco Bay area
Oddometer: 8,796
Quote:
Originally Posted by craydds View Post
Buy a grease zerk with the M10 x 1.0 threads. see http://www.mcmaster.com/#zerk-grease-fittings/=h3u0qv . These thread into the caliper. Use the bleeder valve to block one hole, screw the grease zerk into the other and pump away.
The last time I did it just recently on a RD 350 caliper I just stuck my grease needle in the loose bleeder real hard and started pumping. Sure a bit backed out around the needle but most all of the grease forced the piston out. Both ways definitely work. Good luck!
supershaft is offline   Reply With Quote