View Single Post
Old 04-17-2012, 02:17 PM   #225
mohabie
Adventurer
 
mohabie's Avatar
 
Joined: Dec 2009
Oddometer: 12
Just installed an Acewell into a fiberglass headlight bucket. The outer housing was pressed on, so it was somewhat of a challenge to create an internal bracket and external bezel to make it all work, but I did it!

I got lucky with the plastic bezel, while looking online I found an extruder company that did mass quantities of office furniture computer grommets, the kind you find on your desk that lets you feed those computer wires through the desk in a nice, neat manner. The bezel that trimmed off that grommet looked PERFECT online, so I moved some papers around, popped the one off my desk and wouldnt ya know it, it fit the Acewell PERFECTLY! After expanding the instrument hole on the bucket to fit the new bezel, and building an internal bracket to secure the Acewell from inside the bucket, I was in business. A little bondo to fill in the sides and it will be perfect.

Here it is!





mohabie screwed with this post 03-15-2013 at 10:16 AM
mohabie is offline   Reply With Quote