View Single Post
Old 05-10-2012, 06:30 PM   #9
DiabloADV OP
Semi-Occasional
 
Joined: Oct 2010
Location: Nor Cal, USA
Oddometer: 2,215
Took 'em down to an engine shop for proper measurement. The guy measures at the wide spot of the skirt (perpendicular to the pin). He used mics and then feelers for the final test.

I've got the bare minimum of clearance -- 0.03mm on each side of the skirt.

My end gaps of the rings are at their outside limit, so I'll replace those.

Now...on to the heads!!!
__________________
1974 R90/6 w/1050 kit. Motor only. Seeking a frame.
1970 R60/5

'91 Bill Holland Steel w/Dura Ace
'01 Z3 3.0 Coupe. The Clownshoe.
DiabloADV is offline   Reply With Quote