View Single Post
Old 05-15-2012, 07:47 PM   #664
patanga's Avatar
Joined: May 2009
Location: Australia Qld
Oddometer: 161
Clutch & throttle cables

Not sure if this has already been mentioned on an earlier page but here goes; When fitting clutch and or throttle/choke cables I always tie a piece of string to one end of the cable prior to removing the old cable. I reattach the string to the new cable prior to replacement. That way the string is the lead and I am never in any doubt as to the original routing of the cable as I thread it back through. Saves much time and head scratching.

"The only reason people get lost in thought is because it's unfamiliar territory" (Joe Garcia)

Check us out on facebook at "BMW Airheads Downunder", (The Australia and New Zealand Airhead Community). "B.A.D"

patanga screwed with this post 06-15-2012 at 07:11 PM
patanga is offline   Reply With Quote