View Single Post
Old 05-28-2012, 01:57 PM   #11
Emmbeedee OP
Procrastinators
 
Emmbeedee's Avatar
 
Joined: Mar 2008
Location: Near Ottawa, ON, Canada
Oddometer: 9,350
The Rugged Mount Torx T10 Security Tool Cover

If you lose the cap on your "Rugged Mount" Torx security crew, and you're worried that the tool itself is going to start scratching the paint on your bike, then you might want to listen up. My wife lost the cover on hers, so I found some small diameter tubing, the size I keep around to bleed brakes, and after making sure this hose was clean, I cut an inch or so off and put it on the end of the tool, leaving only about 1/16" sticking out the end.

That's all you need to lock the mount, and this way, it's really unlikely to damage paint or dig a hole in her pocket.



In fact this works so well that I've ditched the covers off my own two Torx tools, and put some tubing on both of those as well.



Why wait until I lose the covers to improve the tool? This way makes it much faster to take the Montana off its mount if I want to take a picture.
__________________
Want to know more about the Garmin Montana? See the Wisdom and FAQ Thread.
Want to know more about the Garmin VIRB? See here.
"The motorcycle, being poorly designed for both flight and marine operation, sustained significant external and internal damage," police noted.

Emmbeedee screwed with this post 05-28-2012 at 03:28 PM
Emmbeedee is offline   Reply With Quote