View Single Post
Old 06-01-2012, 03:32 PM   #1
murdock84 OP
Gnarly Adventurer
 
Joined: Apr 2012
Location: Elizabethtown, PA
Oddometer: 499
Rear Brake Lever Install Help

I ordered a Tourtech rear brake lever with the folding tip. I got the stock lever off and found that the Tourtech one needed the rear hole where the pin goes drilled out a little to get the pin back in. Anyway when I went to put the pin back and then install the brake lever the part that the pin attaches to came out of the little rubber boot. It doesn't appear to want to go back into the rubber boot and stay in place now. It looks like there is grease in there. How do I get this back in there properly?

Hell installing the GPS mount and wiring it up was easier then taking a bolt off the brake pedal and trying to get it back together.

Thanks!
murdock84 is offline   Reply With Quote