View Single Post
Old 06-02-2012, 06:18 AM   #3
Angryrican
know nothing all
 
Angryrican's Avatar
 
Joined: Mar 2011
Location: North NJ
Oddometer: 264
Quote:
Originally Posted by murdock84 View Post
I ordered a Tourtech rear brake lever with the folding tip. I got the stock lever off and found that the Tourtech one needed the rear hole where the pin goes drilled out a little to get the pin back in. Anyway when I went to put the pin back and then install the brake lever the part that the pin attaches to came out of the little rubber boot. It doesn't appear to want to go back into the rubber boot and stay in place now. It looks like there is grease in there. How do I get this back in there properly?

Hell installing the GPS mount and wiring it up was easier then taking a bolt off the brake pedal and trying to get it back together.

Thanks!
put it all together and step on it and it will go right back in, had the same thing happen when I installed mine including having to enlarge the hole a bit
Angryrican is offline   Reply With Quote