View Single Post
Old 07-03-2012, 12:05 PM   #3
moto-treks OP
Back Home
 
moto-treks's Avatar
 
Joined: Dec 2007
Location: Spokane Washington
Oddometer: 1,762
Setting up the base plate

Next it was time to setup the baseplate. The crankcase breather check valve and Temp Sensor need to be installed onto the Rottweiler baseplate.



Once the baseplate is mounted on the bike I rerouted the crankcase breather cutting about 1.5 inches off before it would match up to the check value. Then I tied to connect the temp sensor wire.



But it's not long enough. I've checked everywhere and there is no way for me to get the extra inch or two needed to connect the connector to the Temp Sensor
__________________
Moto Trek'n to New York via the Trans Labrador Hwy, South America

Moto-Treks
moto-treks is offline   Reply With Quote