View Single Post
Old 07-25-2012, 01:28 AM   #122
Dakar83 OP
Gnarly Adventurer
 
Dakar83's Avatar
 
Joined: Jan 2012
Location: Perth WA
Oddometer: 141
Quote:
Originally Posted by Airhead Wrangler View Post
Next time you're there would you mind looking at the diameter markings on the master and slave cylinders? There are a few different sizes available for each, depending on the length of pull needed at the clutch actuating arm as well as the amount of mechanical advantage needed. Thanks for giving me new possibilities for squandering my income.
Your right there is a bit more to it. I haven't got all the detail yet but Dave is going to send it through. He mentioned 2 things the master cylinder size is 10.5, the Handle bar adaptor bracket needs to be sized according to the size of any switch block fitted. In the case of the white HPM it is the largest offset adaptor. I will post more info as it comes to hand.
Dakar83 is offline   Reply With Quote