View Single Post
Old 08-02-2012, 03:03 AM   #151
FreeTheBeast OP
Chocks away!
 
FreeTheBeast's Avatar
 
Joined: Jan 2004
Location: +1.603
Oddometer: 2,917
Thumb Thanks.

Thank you for your perspective. The bolt-on option certainly might be a little easier. Tapping holes in the motor - I suppose one had better do it right the first time.


Quote:
Originally Posted by Voltaire View Post
My engineer mate makes these,I have a set on my bike.
The sleeves are tapped and go thru the motor. The rear mounts get drilled and tapped when you line up the engine/box/swingarm to your liking. All the original engine covers still fit too but you need to move the coils a few mm.

Raises the front up about 30mm.Overlap on shaft/final drive is reduced by about 5-8 mm.
I have touched the RH head down on a few occasions as I'm not much of a hanger offer....( maybe I need a set of Continental )
We tried out the welding method on a stuffed frame but decided the bolt in one would do as racer may go back on road one day....
__________________
Think beyond yourself.

The Hampster Ride - A mainly dirt route to ride the length of New Hampshire.
Max the Motorcycle - children's book written by Mrs. FTB
SmugMug Photo Gallary
FreeTheBeast is offline   Reply With Quote