View Single Post
Old 08-04-2012, 03:33 AM   #5
Gnarly Adventurer
casperghst42's Avatar
Joined: Jan 2008
Location: Rotterdam, The Netherlands (in exile)
Oddometer: 216
Originally Posted by naginalf View Post
I'm looking at getting one of these wonderful multitasking tools,

And the 3/8" adapter:

And I was just wondering what the most common axle nut size is on the KTM and F series bikes that are popular enduro bikes. I don't think there's much I need a 24, 27, or 32mm spanner for on my own bike and since it doesn't matter which size I get, I figured I might as well get the most common size needed for other bikes that might need a hand with a tool or two. Probably a dumb question tho, since you probably always have the tools on hand, but if it doesn't matter, and I can be a tad more prepared, that would be good.
Remember that the 'Motion-Pro-3-8-Drive-Adapter-for-T6-Tire-Lever' is only good for 40nm, and the rear axel nut needs 100nm.

casperghst42 is offline   Reply With Quote