View Single Post
Old 08-05-2012, 09:07 PM   #42
moto-treks OP
Back Home
 
moto-treks's Avatar
 
Joined: Dec 2007
Location: Spokane Washington
Oddometer: 1,768
Quote:
Originally Posted by Helajames View Post
How did you install the PVC ball valve on the CPR plate, cannot find any instructions for disassembly or mounting.
The PVC is made of two parts screwed together with a ball in between. All you have to do is put a wrench on each end and unscrew it. Once its unscrewed you will have two halves so just mount the baseplate in between when you screw the halves back togeather. Make sure you keep the end that was connected to the engine on the outside of the base plate when you install it.
__________________
Moto Trek'n to New York via the Trans Labrador Hwy, South America

Moto-Treks
moto-treks is offline   Reply With Quote